Adjustable hand levers GN 300.2 are ideal whenever parts have to be clamped in a confined space or in a particular lever position. The centre insert is connected to the lever...show more
Adjustable hand levers GN 300.6 with solid stainless steel handle, correspond to applications where "aggressive" surrounding conditions are given, or where stainless steel...show more
Adjustable hand levers GN 604 like all the products of the Ergostyle® family are renowned for their good style but also their ergonomical shape. Pulling the lever disengages the...show more
Safety tension levers GN 312 are used on such applications where a thoughtless or mistaken releasing or re-positioning of the tension lever could lead to an accident. The lever...show more
Clamping plates GN 953.7 are used in connection with position indicators GN 953 / GN 953.2. The mounting holes support typical bore hole patterns. In a simpler manner and...show more
Clamping plates GN 954.7 are used in connection with position indicators GN 954 / GN 954.2. The mounting holes support typical bore hole patterns. In a simpler manner and...show more
Fixed conical handles GN 203 are suitable for applications where the handle is exposed to low loads. For applications with increased loads we recommend to use cylindrical...
With connecting sets GN 900.2 two adjustable slide units GN 900 can be combined to produce an X-Y axis configuration. This combination is achieved with a clamping system which...show more
With connecting sets GN 900.3 two adjustable slide units GN 900 can be combined to produce an X-Z axis configuration. The combination is created by using two connection plates...show more
The unique profile on the rim (small squares) of the knurled screws GN 534 is characteristic of its form and the function.
The hub bores d1 H7 are not provided for in the official standard sheet.
Hand Knobs, Stainless Steel
Hand Knobs, Cast Iron, Threaded Stud Steel
Typical in design are the revolving handles GN 798.1 with their stepped shape consisting of two cylinders giving the operator a better grip.
The cylindrical knobs GN 519.1 do not require a thread at the shaft. During mounting, easy blows with a soft hammer are sufficient to drive the knob into place, the shaft end...show more
When using the cylindrical knobs GN 519, make sure that the threaded pin is not too short. Otherwise the plastic element may break under excessive stress exposure.
Cylindrical handles GN 519.2 are made of blue plastic granulate that is FDA compliant as per FDA CFR.21 and EU 10/2011 as well as visually detectable or metal detectable. The...show more
Disk handwheels DIN 3670 have recessed grips at their back. As a rule they are supplied without handle, but the mounting of a handle is possible. The handwheel diameter d1=80...show more
Handwheels GN 323.8 have a recessed hub to accept position indicators GN 000.8 / GN 000.3. The hub dimensions (for fitting) correspond to those of disc handwheels GN 323 and/or...
Disk handwheels GN 323 have recessed grips at their back.
The underside of the three-lobed knob screws GN 5342 is not recessed, which meets the requirements of a "hygienic" version.
Stainless steel star knobs GN 5334.13 can be captive-attached to a base element with the help of a ball chain or a retaining cable. The star knobs are supplied ready assembled...show more
Control handles GN 112.1 allow fine adjustment. They are connected to a shaft by means of a cross pin. To simplify the installation there is a centred drilling on both sides.
Control handwheels GN 736 are used for setting operations with low torque. Coarse setting is made by means of the cylindrical handle (fingertip grip) followed by fine setting...show more