Art.-Nr.
1209222
Leveranciersnummer
DIN 6330-M12-B
EAN
4045525326927
VPE (Verpakking)
10 stuk
Aantal
1 stuk
Art.-Nr.
1209234
Leveranciersnummer
DIN 6331-M10
EAN
4045525327078
VPE (Verpakking)
10 stuk
Aantal
1 stuk
Art.-Nr.
1076570
Leveranciersnummer
DIN 6331-M12
EAN
4045525327092
VPE (Verpakking)
10 stuk
Aantal
1 stuk
Art.-Nr.
1132314
Leveranciersnummer
DIN 6331-M16
EAN
4045525327122
VPE (Verpakking)
10 stuk
Aantal
1 stuk
Art.-Nr.
1076572
Leveranciersnummer
DIN 6331-M24
EAN
4045525327153
Aantal
1 stuk
Spring loaded side thrust pins GN 715 are versatile and practical elements for holding, positioning and clamping of workpieces. They eliminate costly alternatives, are space...Meer tonen
Control handles GN 112.1 allow fine adjustment. They are connected to a shaft by means of a cross pin. To simplify the installation there is a centred drilling on both sides.
Swing clamps GN 875 are used when the clamping point for inserting and removing the workpiece must be freely accessible on top. During the clamping action, the arm is first...Meer tonen
Zylinderschrauben GN 14580.5 befestigen Bauteile, wenn die Durchbohrung nicht gesenkt werden kann und gleichzeitig die für normale Schraubenköpfe benötigte Bauhöhe nicht zur...Meer tonen
Clampimg pads GN 709.7 are also used in jig and fixture construction, for example for clamping workpieces, as movable bearing surface or as stop. The swivel-mounted ball...Meer tonen
Clampimg pads GN 709.8 are also used in jig and fixture construction, for example for clamping workpieces, as movable bearing surface or as stop. The swivel-mounted ball...Meer tonen
Toggle clamps GN 810.1 work according to the toggle principle: lever and clamping bar move in the same direction. In the clamped position the operating lever is in its vertical...Meer tonen
Swivel ball joint mounting clamps GN 487 allow precise and stepless adjustment of the ball pivot within the swivel range. This makes it easy to position and adjust components...Meer tonen
Hand Knobs, Aluminum
The clamping bore axes of the two-way connector clamps GN 132.9 are arranged at an angle of 90° to each other. They hold typical construction tubes with full surface contact...Meer tonen
Stainless steel leveling sets GN 350.5 are used for leveling, adjusting and linking operations. The spherical washer allows precise installation of two non parallel planes at a...Meer tonen
Levelling sets GN 350.5 are used for levelling, adjusting and linking operations. The spherical washer allows precise installation of two non parallel planes at a required...Meer tonen
