The original ELESA design with 5 recess grips is typical for star knobs with threaded stud GN 5334.4. This form gives these grips an appealing look and additionally allows a...Meer tonen
Star knobs GN 6336.12 have a ball pin whose diameter is smaller than the core diameter of the thread. The movable thrust pad is easily clipped on and taken off. The thrust pads...
Star Knobs, Cast Iron, Threaded Stud Steel
Art.-Nr.
1342938
Leveranciersnummer
6336.4-TE-40-M8-40
EAN
4045525183971
VPE (Verpakking)
25 stuk
Aantal
1 stuk
Art.-Nr.
1209758
Leveranciersnummer
6336.4-TE-63-M12-60
EAN
4045525341173
VPE (Verpakking)
10 stuk
Aantal
1 stuk
Star Knobs, Aluminum, Threaded Stud Stainless Steel
Art.-Nr.
1209783
Leveranciersnummer
6336.5-ES-40-M8-20
EAN
4045525884489
VPE (Verpakking)
10 stuk
Aantal
1 stuk
Star Knobs, Stainless Steel
The star knobs have an immaculate contact or clamping surface thanks to the protruding Stainless Steel bushing.
Star knobs GN 6336.10 with brass or plastic thrust pad are used when indentations or damage is to be avoided.
Stainless steel star knobs GN 5335.4 are a special development intended for the food processing machinery industry. The smooth and enclosed areas as well as the large corner...Meer tonen
Star knobs GN 5435 are intended for use in hygienic areas. The sealed mounting surface enables fastening without dead spaces. The high quality finish and the large corner radii...Meer tonen
Star Knobs, Aluminum
Star knobs GN 6336.2 with all stainless steel bushing (main dimensions of DIN 6336) have important advantages: The face of the bushing is exactly square to the bore and is with...Meer tonen
Star knobs GN 5333 meet highest quality requirements. Due to a special manufacturing process the mould parting line can be avoided.
Star knobs GN 6336.13 can be captive-attached to a base element with the help of a ball chain or a retaining cable. The star knobs are supplied ready assembled (with retaining...
The influence of a washer on the quality of the screwed connection is very often underestimated. With washers GN 6339, high quality preloaded screwed connections can be...Meer tonen
Headed dowels GN 6321.1 can also be used as feet and supports.
When flow indicators GN 655 are used, a rotor rotates above a minimum volume flow rate Q, depending on the medium and its viscosity. The flow rate is visible from all sides....Meer tonen
T-handles GN 563 can be used on operating handles as well as on clamping fixtures. These handles lend themselves ideally for very high manual clamping forces.
