Art.-Nr.
1130836
Aantal
1 stuk
Art.-Nr.
1074327
Aantal
1 stuk
Fork joints GN 751 consist of a fork head according DIN 71752 and a pin with axial shaft safety (Type KL and SL) or a snap-on spring pin (Type B). Size d1 = 12 is supplied with...Meer tonen
In addition to the standard travel lengths specified in the above table for the double tube linear actuator GN 492 any length inside the maximum travel length is available. In...Meer tonen
Tube end plugs GN 991 have been designed for sealing tube ends for safety or optical reasons. They are pressed into the tube end either by hand or with a mallet.
The clamping bore of flanged connector clamps GN 145 is mechanically machined and designed for construction tubes GN 990 or DIN 2391, DIN 2395 and DIN 2462. Flanged connector...Meer tonen
The clamping bore of flanged connector clamps GN 146.3 is mechanically machined and designed for construction tubesGN 990 or DIN 2391, DIN 2395 and DIN 2462. Flanged connector...Meer tonen
The clamping bores of two-way connector clamps GN 134 are not machined and designed for construction tubes GN 990 or DIN 2391, DIN 2395 and DIN 2462 . The versions with square...Meer tonen
Ball joint heads GN 648.6 are similar to DIN ISO 12240-4, series K (formerly DIN 648 K).
Art.-Nr.
1484919
Leveranciersnummer
911-63-M8-25-SR
EAN
4045525721999
Aantal
1 stuk
Ball joint heads GN 648.1 are similar to DIN ISO 12240-4, series K (formerly DIN 648 K).
Art.-Nr.
1668797
Leveranciersnummer
10I-40408L-N-2-4
EAN
4045525892668
VPE (Bos)
4 stuk
Aantal
4 stuk
The clamping bore of flanged connector clamps GN 147 is not machined and designed for construction tubes GN 990 or DIN 2391, DIN 2395 and DIN 2462. The versions with square...Meer tonen
For mounting clamps, the clamping kits GN 511 replace the socket cap screws with hexagonal socket DIN 912. It is used on all clamping points where repeated clamping actions are...Meer tonen
The clamping bores of GN 132 two-way connector clamps are mechanically machined and designed for construction tubes GN 990 or DIN 2391, DIN 2395 and DIN 2462. At the screw...Meer tonen
The permissible r.p.m. of universal joints with friction bearing DIN 808 is to a large extent dependent on the type of application such as load, duration, angular disposition as...Meer tonen
The clamping bore of base plate connector clamps GN 163 is mechanically machined and designed for construction tubes GN 990 or DIN 2391, DIN 2395 and DIN 2462. At the screw...Meer tonen
The clamping bore of swivel clamp connectors GN 276 is mechanically machined and designed for construction tubes GN 990 or DIN 2391, DIN 2395 and DIN 2462. At the screw location...Meer tonen
Aluminum profiles GN 10b are produced by extrusion molding. They can be used, for example, to easily construct protective enclosures, workplace equipment or jigs. Aluminum...Meer tonen