Locking pins with axial lock GN 214.6 are used for quick fixing, connecting and locking of various jig and fixture systems. A typical application is location pins which have to...show more
Spacers GN 6220 are commonly used as spacing rods. They allow parts to be fastened with an offset parallel to their mounting plane. Type A is also used as a connecting nut. Any...show more
With spring latches GN 722.2, the plunger pin is retracted over the curve of the guide by a 180° turn of the latch. The notch at the upper end of the curve causes the latch to...show more
Stainless steel spring plungers GN 614 are used as detents as well as for push-on and push-off applications and ejectors. A tolerance of H7 for the location hole of d1 is...
Characteristic of the star knobs GN 5337.4 is the 5 lobes. They not only give the knobs a specific style but this shape has also enabled the operator to achieve a higher torque....show more
Characteristic of the star knobs GN 5337.7 is the 5 lobes. They not only give the knobs a specific style but this shape has also enabled the operator to achieve a higher torque.
Star knobs GN 6336.2 with all stainless steel bushing (main dimensions of DIN 6336) have important advantages: The face of the bushing is exactly square to the bore and is with...show more
Star Knobs, Plastic, Bushing Brass
Star Knobs, Cast Iron, Threaded Stud Steel
The star knobs have an immaculate contact or clamping surface thanks to the protruding steel bushing.
The softline coating makes the star knobs with threaded stud GN 5337.6 particularly user-friendly and ergonomic. The soft, slip-proof contact area improves the contact both in...show more
Studs DIN 6379 are primarily used with T-nuts DIN 508. Complete clamping screws can be created by combining them with hexagon nuts DIN 6330 and washers DIN 6340. The official...show more
Load rings GN 5860 rotate running in ball bearings. The freely rotating ring allows the bolts to hold loads in any tensile direction. The rated load-bearing capacity is shown...show more
The load rings GN 586.1 can be folded and rotated into all approved directions, carrying the full load in any tension direction. They offer a high load carrying capacity and...show more
T-nuts GN 50i fasten attachments and accessories in the slot of aluminum profiles. The spring-loaded ball secures the T-nut against unwanted slipping within the slot, making...show more
Toggle latches GN 831.2 are used for the secure holding of flaps, container lids, machine coverings and similar applications. The clamping stroke exceeds the dead centre point...show more
The folding handles with recessed tray GN 425.8 are used if the handle is to protrude by a maximum of 3 mm when folded down. In type A, the folding handle is held in both end...show more
Latch type toggle clamps GN 851.3 are compact in design and can be used to ensure high holding capacities. When closing the spanner, a safety hook positively locks onto the...show more
Cabinet U-handles GN 425.3 are made of bent steel sections and are affixed by welding. The holes d2 serve, if necessary, for inserting dowel pins or guide pins that provide a...show more
Stainless Steel Wing Screws